Roshe Power Ltd. - Stage Status Indicator Board

Stage Status Indicator Board Instructions:

Drawing - The Roshe Power Stage Status Indicator Board

The technology employed within this equipment utilises the band of frequencies that is also used for remote control of car and house alarm systems. Therefore there is always a remote possibility that false triggering may occur if the unit is used in densely populated areas, however this is unlikely due to the large number of codes available.
Under ideal conditions the transmitter/receiver combination will have a range of up to 25 metres (80ft)

The Transmitter/Indicator Board are supplied as matched pairs, it is important that these are kept together as each keyfob will only work with its associated receiver.
If an additional or replacement Keyfob is required please quote Serial No on rear of Status Board

Instructions for use:

When button 'I' is pressed, the Red lamp will illuminate and the bell will ring once. When pressed a second time, the lamp will extinguish and the bell will sound twice.
There is a switch on the underside of the bell to enable it to operate in 'Whisper' mode.

If button "II" is pressed, the Green lamp will iluminate. When pressed a second time the lamp will extinguish.

If additional lamps or bells are required, they may be connected to the euro-sockets on the base of the board. (NOTE - Do not exceed 100W load)

Troubleshooting:

The lamps fail to illuminate on status board - Check Bulbs / Internal fuse - Replace if necessary.
The red light does not illuminate on transmitter when button is pressed - check battery type 23A - Replace if necessary.
The Receiver does not respond to the transmitter - Check batteries and range.
Also, if multiple units are used, ensure that transmitter/receiver pairs/sets are correct.
The Receiver is triggered randomly - Possibly another transmitter is being used within the area that uses the same code - use alternative equipment.